 ModemHelp.Net Recommends: Click here to run a Free driver update scan
D-link - DSL-302g
Guides, Specs, and Important URLs:
DSL Type: aDSL
Manufacturer's Website: http://www.dlink.com
Screenshots: n/a
Modem Configuration Page Address(es) [ETHERNET]: http://10.1.1.1/
Modem Configuration Page Address(es) [USB]: http://10.1.1.2/
Modem Default IP Address(es) [ETHERNET]: 10.1.1.1
Modem Default IP Address(es) [USB]: 10.1.1.2
Connection Types:
- RJ-11 port ADSL telephone line connection
- 1x RJ-45 ports for 10/100BASET Ethernet connection
- 1x USB port for USB connection
Status Lights:
- [Power]
Steady green light indicates the unit is powered on. When the device is powered off this remains dark.
- [Status]
Steady light indicates that modem is on but that firmware did not load correctly. A Flashing light indicates that the modem is on and that the firmware has loaded correctly. If it remains off or turns off it means that there is a hardware failure.
- [ADSL Link/Act]
If led light is on it means that it the modem has obtained Sync. A flashing led light means that it is training, trying to obtain Sync. A flickering led light indicates aDSL activity and if it's not on, then, it means it does not detect the aDSL signal.
- [Ethernet Link/Act]
A solid green light indicates thatthe modem is connected to ethernet card. Flickering light indicates ethernet activity. If it remains off or turns off, then it means that there is no ethernet connection
- [USB Link/Act]
A solid green light indicates connection via the USB port. Flickering light shows USB activity and if it's off, then there is no USB connection established
Misc Notes:
- USB and Ethernet connection cannot be used at the same time.
|
